Kohler STERLING 7109 Serie Guide D'installation Et D'entretien page 26

Aplique sellador de silicona (cont.)
Aplique una tira en forma de L de sellador 100% de silicona en cada extremo
exterior del reborde de la bañera donde se van a instalar las paredes laterales.
Aplique una tira de por lo menos 1/4" (6 mm) de ancho y 1" (2,5 cm) por 4" (10,2
cm) de largo, como se muestra.
Continúe inmediatamente en la sección "Fije las paredes circundantes".
9.
Secure the Wall Surrounds
Bath Flange
Bride de la baignoire
Reborde de la bañera
Wall Surround
Mur avoisinant
Paredes circundantes
1/32"
(1 mm)
Bath
Baignoire
Bañera
CAUTION: Risk of property damage. Wall surrounds must rest within 1/32" (1
mm) (the thickness of a credit card) from the bath rim to ensure proper water
management and to prevent leakage.
Remove the temporary roofing nail from the back wall.
Ensure that the wall surrounds are properly secured and seated on the bath. The
front edges of the end walls must be flush with the front edge of the bath. If a gap
exists, pull the end walls slightly forward.
CAUTION: Risk of product or property damage. If using truss head screws
rather than roofing nails, do not overtighten the screws. Excessive tightening can
damage the wall flange.
Starting from the bottom of the end walls and working up, secure the end walls to
the studs approximately every 12" (30.5 cm). If roofing nails are used, nail through
the dimples on the wall flanges. If using truss head screws, fasten the screws
through the dimples on the wall flanges. Do not overtighten the truss head
screws.
1064911-2-C
Stud/Montant/Poste de madera
Wall Flange
Bride du mur
Reborde de la pared
26
Shim if necessary.
Caler si nécessaire.
Utilice cuñas de ser
necesario.
Roofing Nail or
Flathead Screw
Clous pour toiture ou
vis à tête plate
Clavo de techar o
tornillo de cabeza plana
Sterling