KitchenAid 4KFP750 Guide D'utilisation page 10

Preparing the Food Processor for Use
WARNING
Cut Hazard
Handle blades carefully.
Failure to do so can result in
cuts.
Before First Use
Before using your Food Processor for
the first time, wash the work bowl,
work bowl cover, mini bowl, feed
tube pusher, discs, and blades either
by hand or in the dishwasher (see
"Cleaning the Food Processor" on
page 12).
Work Bowl Assembly
1. Place the Food Processor base on a
dry, level countertop with the
controls facing forward. Do not
plug in the unit until it is
completely assembled.
2. With the handle just to the left of
center, place the work bowl on the
base, fitting the center opening
over the power shaft.
3. Grasp the work bowl handle and
turn the bowl to the right until it
locks into position.
4. Insert the desired accessory into
the work bowl. See pages 9–10
for accessory instructions.
5. Place the work bowl cover on the
work bowl with the feed tube just
to the left of the work bowl
handle. Grasp the feed tube and
turn the cover to the right until it
locks into place.
NOTE: Do not attach the cover to the
work bowl before the work bowl is
locked on the base. Damage to the
work bowl may result.
6. Fit the 2-piece food pusher into
the feed tube.
7. Plug into a proper electrical outlet.
NOTE: Your Food Processor will not
operate unless the work bowl and
work bowl cover are properly locked
on the base.
Do not remove the work bowl from
the base without first removing the
work bowl cover. Damage to the
work bowl may result.
8