Kuppersbusch FK4500.0i Mode D'emploi page 24

24
Problem
The compressor does not
start immediately after
pressing the ,IntensiveCool‐
ing or after changing the
temperature.
Water flows on the rear plate
of the refrigerator.
Water flows into the refriger‐
ator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The IntensiveCooling func‐
tion is switched on.
This is normal, no error has
occurred.
During the automatic de‐
frosting process, frost melts
on the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The IntensiveCooling func‐
tion is switched on.
The temperature regulator is
not set correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The IntensiveCooling func‐
tion is switched on.
Solution
Refer to "IntensiveCooling
function".
The compressor starts after
a period of time.
This is correct.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Switch off IntensiveCooling
manually, or wait until the
function resets automatically
to set the temperature. Re‐
fer to "IntensiveCooling
function".
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Refer to "IntensiveCooling
function".