Braun 5768 Mode D'emploi page 12

MultiHeadLock switch (head lock)
• To shave hard-to-reach areas (e.g. under the nose) slide the MultiHeadLock switch
(3) down to lock the shaver head. The shaver head can be locked in five positions.
• To change position, move the shaver head with your thumb and forefinger back or
forth. It will automatically click into the next position.
Long hair trimmer
To trim sideburns, moustache or beard press the release button (8) and slide the long
hair trimmer (6) upwards.
Travel lock
The lock symbol (5a) lights up in the shaver display when the shaver has been locked to
avoid unintended starting of the motor (e.g. for storing it in a suitcase).
• Activation: By pressing the on/off switch (4) for 3 seconds the shaver is locked. This is
confirmed by a beep sound and the lock symbol in the display. Afterwards the display
turns off.
• Deactivation: By pressing the on/off switch for 3 seconds again the shaver is
unlocked.
Cleaning
Cleaning under running water
• Switch on the shaver (cordless) and rinse the shaver head under hot running
water until all residues have been removed. You may use liquid soap without
abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
• Next, switch off the shaver, press the release button (2) to remove the Foil & Cutter
cassette (1) and let it dry.
• If you regularly clean the shaver under water, then once a week apply a drop of light
machine oil on top of the Foil & Cutter cassette.
Cleaning with a brush
• Switch off the shaver. Remove the Foil & Cutter cassette (1) and tap it out on a flat
surface. Using the brush, clean the inner area of the pivoting head. Do not clean the
cassette with the brush as this may damage it!
Accessories
Braun recommends changing your shaver's Foil & Cutter cassette every 18 months to
maintain your shaver's maximum performance.
Available at your dealer or Braun Service Centres:
• Foil & Cutter cassette: 52S/52B
• Braun Shaver cleaner spray
13