HP Photosmart D7400 Serie Guide D'utilisation page 14

Chapter 2
5. Follow the onscreen prompts on the display to complete the connection.
6. When the HP Photosmart connects successfully to the network, go to your computer
to install the software on each computer that will use the network.
NOTE:
timed out after you activated SecureEasySetup. Repeat the above task, ensuring
that you complete the steps on the control panel of the HP Photosmart
immediately after pressing the button on the wireless router or access point.
Wireless ad hoc network setup
Use this section if you want to connect the HP Photosmart to a wireless-capable computer
without using a wireless router or access point.
NOTE:
access point. However, it provides little flexibility, a low level of network security, and
slower network performance than with a wireless router or access point.
In order to connect the HP Photosmart to your computer (ad hoc), you need to create an
ad hoc network profile on your computer. This includes choosing a network name (SSID)
and WEP security (optional but recommended) for your ad hoc network.
To set up the HP Photosmart on a wireless
ad hoc network, you need to do the
following:
First, collect all of the required materials.
Next, prepare your computer by creating a
network profile.
Next, run the Wireless Setup Wizard.
Finally, install the software.
14 HP Photosmart D7400 series
If the connection fails, the wireless router or access point might have
An ad hoc connection is available if you do not have a wireless router or
See this section:
"What you need for an ad hoc network"
on page 15
"Create a network profile for a Windows XP
computer" on page 15
"Create a network profile for other operating
systems" on page 16
"Connect to a wireless ad hoc network"
on page 16
"Install the software for a network connection"
on page 17