Publicité
Les langues disponibles
Les langues disponibles
en-us Conversion to LP gas
Double burner, second orifice
Fasten the orifices.
3.
Save the orifices removed from the appliance for future
4.
use.
5.3 Adjusting the gas valves
Turn the control knobs to position off.
1.
Pull off the control knobs.
2.
Remove the screws at each burner.
3.
Tilt up the maintop from the front
4.
grounding connection . Then lift off the main top from
the cooktop .
16
5.
6.
7.
and unplug the
8.
9.
Remove the electronics pack from the control panel:
With a flat head screwdriver carefully pry the black
‒
tabs at the front away from the panel one by one,
while lifting up the transparent cover of the
electronics pack to disengage the tabs.
When all tabs are unlocked you can lift off the
‒
electronics pack.
3
2
1
Remove the black disks from the valve stems. Make
sure the springs underneath the black disks do not
come off.
Adjust the black T10 star head setting screw with a T10
star head screwdriver. Refer to the burner chart for the
correct setting of the setting screws (M).
→ "Burner chart", Page 17
Use setting
for LP Gas. The setting screws must
‒
be tightened properly.
Use setting
for natural gas. The setting screws
‒
must finish flush with the fitting.
The dual-flame burner has 2 setting screws.
Replace the white disks and the electronics pack.
Ensure that the gaskets around the burner bases are in
place.
Publicité
