Carson 1st Go-Kart RTR 103016 Mode D'emploi page 6

Tools needed for the assembly
GB
Modelling knife
Philips screwdriver
(small and big)
1,5/ 2 / 2,5 mm
a. Your 3 channel radio system
Please read the instructions provided with your radio system
before using it.
The servos must be set at the centre position before
installation. To set the servos at a neutral position, turn on
the transmitter and receiver. Set the trim levers in the centre
position and turn off the receiver, and then the transmitter. The
servos will be in proper neutral position for installation.
Receiver antenna
Engine
throttle
servo
6 CARSON 1st Go-Kart RTR 103016
74053 Instant adhesive
Hexagonal wrench
74023
Batteries for receiver
Switch
Steering servo
53339 Needle nose pliers
13118 Tweezers
(only for RTR version)
Transmitter
74034 Scissors
74003 Side cutter
13305
74035