Install Workstation To Garage Wall; Attach Fold-Down Door - Whirlpool Gladiator ARMOIRE DE POSTE DE TRAVAIL Instructions D'assemblage

Attach Lower Mounting Bracket
⁵⁄₁₆
F1 " Allen-head bolt (4)
1. With the mounting bracket rims pointing down, align the two
slots in each side of bracket (P7) with the slots in each of the
sides (P1 and P3).
2. Working from the back, insert a bolt (F1) through the bracket (P7)
and into the sides (P1 and P3).
3. Make sure the distance from the top of the upper bracket to the
top of the lower bracket measures 24". Completely tighten the
bolts.
NOTE: The lower bracket slots allow for adjustments.
P3
P7
Mount on GearWall ® Panels or GearTrack™ Channels
1. Determine workstation mounting location on GearWall
GearTrack™ channels.
2. Using two or more people, engage the mounting bracket into the
wall slots by lifting up, pushing toward the wall and lowering the
bracket rims into the slots.
3. Inspect the workstation from the sides to ensure the wall-
mounting bracket is fully engaged slots as shown.
A
B
A. Bracket rim
B. Slot
F1
P4
P1
P2
® panels or
C
C. Mounting bracket
fully engaged

Install Workstation to Garage Wall

Tools and Parts Needed: ¹⁄₂" Socket wrench, ³⁄₈" Ratchet wrench
with 2" extension, ⁵⁄₁₆" x 1¹⁄₂" Lag screws (6), ⁵⁄₁₆" Flat washers (6)
IMPORTANT: The holes in the top (P5) and the bottom (P2) are
spaced to allow you to mount the workstation to your garage wall
studs.
1. Locate the wood studs in your garage wall. Align three holes at
the top and three holes at the bottom with the wood studs, and
mark the location of the holes.
2. While two or more people hold the workstation against the wall,
attach the workstation to the garage wall using ⁵⁄₁₆" flat washers
and ⁵⁄₁₆" x 1¹⁄₂" Lag screws (not provided).
3. Using a ¹⁄₂" socket wrench, fully tighten the screws.
P3
A
A. Holes for standard wall mounting

Attach Fold-down Door

F1 F2
⁵⁄₁₆
F1 " Allen-head bolts (6)
⁵⁄₁₆
F2 " Flange nut (2)
1. Insert the door (P8) hinge brackets, into the bottom of the
workstation frame, as shown.
2. While one person holds the door (P8) in place, align the holes in
the bottom corners of the door (P8) with the corner holes in the
workstation sides (P1 and P3). Fasten with two Allen-head bolts
(F1) at each corner.
A
P5
P4
P1
P2
F5 F6
F5 Door catch pin (2)
F6 Star nut (2)
5