VOLTCRAFT VLP-USB Série Mode D'emploi page 55

VLP 2403 USB
The "OVER VOLTAGE" display lights
up.
The "OVER VOLTAGE" display goes
out after resetting (switch-off).
The preset level for overvoltage protection has been exceeded. OUT-
PUT A or OUTPUT C was switched off.
Reset the device as outlined in chapter "Setting the overvoltage protec-
tion (OVP) and resetting the device" on page 47.
The switch-off time was too short.
Leave the laboratory power supply off for at least 3 to 5 seconds.
If the OVP display does not go out after a sufficient switch-off phase,
please contact our service department.
55