Mitsubishi Electric CITY MULTI PAR-40MAAU Manuel D'installation page 19

[1] Clock display
[Button operation]
1 Select "Clock" from the display details setting screen, and press the
F4 button (Change) to bring up the clock display setting screen.
2 Use the F1 through F4 buttons to select "Yes" (display) or "No" (non-
display) and its format for the Status display and the Main display.
3 Save the settings with the SELECT button. (The factory settings are
"Yes" (display) and "12 h" format.)
Clock display: Yes (Time is displayed on the Status display and the Main display.)
No (Time is not displayed on the Status display and the Main display.)
Display format: 24-hour format
12-hour format
AM/PM display (Effective when the display format is 12-hour): AM/PM before the time
Note: Time display format will also be reflected on the timer and schedule setting display. The time is displayed
as shown below.
12-hour format: AM12:00 ~ AM1:00 ~ PM12:00 ~ PM1:00 ~ PM11:59
24-hour format:
[2] Temperature unit setting
[Button operation]
Move the cursor to "Temperature" from the display details setting screen,
and select the desired temperature unit with the F3 or F4 button. (The
factory setting is Fahrenheit (ºF).)
• ºC: Temperature is displayed in Centigrade. Temperature is displayed
in 0.5- or 1-degree increments, depending on the model of indoor
units.
• ºF: Temperature is displayed in Fahrenheit.
• 1 ºC: Temperature is displayed in Centigrade in 1-degree increments.
[3] Room temperature display
[Button operation]
Move the cursor to "Room temp." on the display details setting screen, and select the desired
setting with the F3 or F4 button.
(The factory setting is "Yes".)
• Yes: Room temperature appears on the Main display.
• No: Room temperature does not appear on the Main display.
Note: Even when "Yes" is set, the room temperature is not displayed on the Main display in the "Basic" mode.
[4] Auto (single set point) mode display setting
[Button operation]
Move the cursor to "Auto mode" from the display details setting screen, and select the desired
mode with the F3 or F4 button. (The factory setting is "Yes.")
• Yes: "Auto Cool" or "Auto Heat" is displayed during operation in the Auto (single set point) mode.
• No: Only "Auto" is displayed during operation in the Auto (single set point) mode.
0:00 ~ 1:00 ~ 12:00 ~
– 19 –
AM/PM after the time
13:00 ~ 23:59