Publicité
Les langues disponibles
Les langues disponibles
8
Test run
Note: Maintenance password is required.
(1) Read the section about Test run in the indoor unit Installation Manual before performing a test run.
(2) At the Main display, press the Setting button and select Service>Test run>Test run.
(3) Press the ON/OFF button to cancel the test run if necessary.
(4) Refer to the indoor unit Installation Manual for the detailed information about test run and for
how to handle the errors that occur during a test run.
Note: Refer to section 10 "Service menu" for information about the maintenance password.
9
Initial settings (Remote controller settings)
Note: Administrator password is required.
From the Main display, select Main menu>Initial setting, and make the remote controller settings on
the screen that appears.
Basic setting menu
(1) Main/Sub setting
When connecting two remote controllers, one of them needs to be designated as a sub controller.
[Button operation]
1 When the F3 or F4 button is pressed, the currently selected setting will
appear highlighted. Select "Sub", and press the SELECT button to save
the change.
2 Press the MENU button to return to the Main menu screen. (This button
always brings up the Main menu screen.)
(2) Clock setting
[Button operation]
1 Move the cursor with the F1 or F2 button to the desired item.
2 Change the date and time with the F3 or F4 button, and press the
SELECT button to save the change. The change will be reflected on
the clock display on the Status display and the Main display.
Note: Clock setting is necessary for time display, weekly timer, timer setting and
error history. Make sure to perform clock setting when the unit is used for
the first time or has not used for a long time.
Note: If a given system has no system controllers, the clock time will not
automatically be corrected. In this case, periodically correct the clock time.
Basic setting menu
• Main/Sub
• Clock
• Daylight saving time
• Administrator password
Display setting menu
• Main display
• Remote controller display
details setting
• Contrast•Brightness
• Language selection
– 16 –
Operation setting menu
• Auto mode
• Setback mode
Note: The initial administrator password
is "0000." Refer to section (4)
"Administrator password setting"
for how to change the password.
Publicité
