ZANKER KBB29011SK Notice D'utilisation page 22

Problem
There is too much frost and ice.
Water flows on the rear plate of the
refrigerator.
Water flows inside the refrigerator.
Water flows on the floor.
The temperature in the appliance is
too low/too high.
If the advice does not lead to the desired
result, contact the nearest Authorised
Service Centre.
22
Possible cause
Food products placed in the ap-
pliance were too warm.
The door is not closed correctly.
The door is not closed correctly
or the gasket is deformed/dirty.
The water drainage plug is not
correctly positioned.
Appliance is fully loaded and it is
set to the lowest temperature
Temperature set in the appliance
is too low and the ambient tem-
perature is too high.
Temperature is set incorrectly.
During the automatic defrosting
process, frost melts on the rear
plate.
Food products prevent the water
to flow into the water collector.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often.
There is no cold air circulation in
the appliance.
Solution
Allow food products to cool to room
temperature before storing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drainage plug in the
correct way.
Set a higher temperature. Refer to
"Operation".
Set a higher temperature. Refer to
"Operation"
Refer to "Operation" .
This is correct.
Make sure that food products do not
touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to the
evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature de-
crease to room temperature before
storage.
Add less food products at the same
time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air circula-
tion in the appliance.