Bosch MKKL82AF3A Notice D'utilisation page 26

en Installation and connection
Using the appliance
Defrost the freezer compartment regularly.
Close the freezer compartment door properly.
--------
Before using your appliance
for the first time
Remove leaflets, adhesive tape and
1.
protective film.
Clean the appliance.
2.
~ "Cleaning" on page 34
Electrical connection
Caution!
Do not connect the appliance to
electronic energy saver plugs.
You can connect the appliance
Note:
to mains-controlled and sine-controlled
inverters.
Mains-controlled inverters are used for
photovoltaic systems which are
connected directly to the national grid.
Sine-controlled inverters must be used
for isolated applications. Isolated
applications, e.g. on ships or in
mountain lodges, which are not
connected directly to the national grid.
26
A layer of hoarfrost or ice in the freezer compart-
ment impairs refrigeration of the frozen food and
increases power consumption.
The freezer compartment will become covered in
thick ice. If greater demands are made of the appli-
ance, the power consumption will increase.
After installing the appliance, wait at
1.
least 1 hour before connecting it to
prevent damaging the compressor.
Connect the appliance via a
2.
correctly installed socket.
The socket must comply with the
following data:
Socket with
Conductor
Fuse
Outside Europe: Check whether the
indicated current type of the
appliance corresponds with the
values of your power supply.
Appliance specifications are on the
rating plate.
Connect the appliance to a socket
3.
near the appliance.
The socket must be freely
accessible even after the appliance
has been installed.
220 V ... 240 V
50 Hz
10 A ... 16 A