Table Des Matières - Makita DTW1001 Manuel D'instruction

Impact force/bolt size corresponding chart (reference)
Impact force grade displayed on
panel
Hard
Medium
Soft
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Selecting correct impact socket
Always use the correct size impact socket for bolts and
nuts. An incorrect size impact socket will result in inac-
curate and inconsistent fastening torque and/or damage
to the bolt or nut.
Installing or removing impact socket
Only for Model DTW1001,DTW1002 (optional
accessory)
CAUTION:
Make sure that the impact socket
and the mounting portion are not damaged before
installing the impact socket.
For impact socket without O-ring
and pin
1
2
► 1. Impact socket 2. Square drive
Align the square of the impact socket with the square
drive and push the impact socket onto the square drive
DTW1001
Standard bolt High tensile
bolt
M20 - M30 M16 - M24
(3/4" - 1-1/4") (5/8" - 1")
M16 - M24 M12 - M20
(5/8" - 1") (1/2" - 3/4")
M12 - M20 M10 - M16
(1/2" - 3/4") (3/8" - 5/8")
8 ENGLISH
DTW1002
Standard bolt High tensile
bolt
M20 - M30 M16 - M24
(3/4" - 1-1/4") (5/8" - 1")
M16 - M24 M12 - M20
(5/8" - 1") (1/2" - 3/4")
M12 - M20 M10 - M16
(1/2" - 3/4") (3/8" - 5/8")
until it locks into place. Tap it lightly if required.
To remove the impact socket, simply pull it off.
For impact socket with O-ring
and pin
Only for Model DTW1001
1
2
► 1. Impact socket 2. O-ring 3. Pin
Move the O-ring out of the groove in the impact socket
and remove the pin from the impact socket. Fit the
impact socket onto the square drive so that the hole in
the impact socket is aligned with the hole in the square
drive.
Insert the pin through the hole in the impact socket and
square drive. Then return the O-ring to the original posi-
tion in the impact socket groove to retain the pin.
To remove the impact socket, follow the installation
procedures in reverse.
DTW800
Standard bolt High tensile
bolt
M20 - M24 M16 - M22
(3/4" - 1") (5/8" - 7/8")
M14 - M20 M10 - M16
(9/16" - 3/4") (3/8" - 5/8")
M12 - M16 M10 - M12
(1/2" - 5/8") (3/8" - 1/2")
3