Weston 33-0201-W Mode D'emploi page 9

GRINDER ASSEMBLY
WARNING!
appliance, make sure the appliance is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
1. Remove the Ring Nut, Grinding Plate, Knife
and Auger from the Grinder Head before
installing the Grinder Head to the Main Body.
2. Align the notches on the Grinder Head with
the tabs on the Main Body.
3. Press the Grinder Head against the Motor
and rotate it counterclockwise until it locks into
place (FIGURE B).
4. Insert the Auger into the Grinder Head,
Auger Driver end first (FIGURE C).
5. Place the Grinder Knife onto the square
portion of the Auger Pin. The cutting edges
(flat side) of the Knife should be facing out
(FIGURE D).
6. Place the Grinding Plate of your choice onto
the Auger Pin. Make sure the notch of the
Grinder Plate fits into the positioning pin of the
Grinder Head (FIGURE C).
7. Turn the Ring Nut clockwise onto the
threaded end of the Grinder Head until it
touches the Grinder Plate and is snug. DO
NOT over-tighten the Ring Nut.
8. Place the Tray on the upright part of the
Grinder Head. NEVER use the Grinder without
the Tray installed!
WARNING!
READ AND FULLY
UNDERSTAND ALL
INSTRUCTIONS AND
WARNINGS PRIOR
TO USING THIS UNIT.
Never leave this appliance
unattended!
Before cleaning, assembling or disassembling the
Auger
Pin
Cutting edges of the Knife facing out.
FIGURE B
FIGURE C
FIGURE D
9