Publicité
Les langues disponibles
Les langues disponibles
GENERAL SAFETY RULES
READ AND FULLY UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
PRIOR TO USING THIS UNIT. YOUR SAFETY IS MOST IMPORTANT!
FAILURE TO COMPLY WITH PROCEDURES AND SAFE GUARDS MAY
RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE. REMEMBER:
YOUR PERSONAL SAFETY IS YOUR RESPONSIBILITY!
1. DO NOT use the Grinder without the
Tray secured into place.
2. ALWAYS DISCONNECT Grinder from
power source before servicing, changing
accessories or cleaning the unit.
3. Plug the Grinder into a standard 120 Volt,
60 Hz wall outlet.
4. DO NOT USE the Grinder if the Power
Cord, Plug or any other parts are damaged.
If the Power Cord or the Grinder is
damaged, call Customer Service. DO NOT
ATTEMPT TO REPLACE THE CORD. Be
sure to not allow the Power Cord to drape
into your work area. Check that all parts are
operating properly, and perform the intended
functions. Check for alignment of moving
parts or any other conditions that may affect
the operation.
5. NEVER use any accessories or parts from
other manufacturers. Doing so will VOID
YOUR WARRANTY and may cause fire,
electrical shock or injury.
6. TO PROTECT AGAINST RISK
OF ELECTRICAL SHOCK: DO NOT
SUBMERGE THE MAIN GRINDER BODY
INTO WATER OR LIQUID. BE SURE THE
GRINDER IS DISCONNECTED FROM THE
POWER SOURCE BEFORE CLEANING.
Wash all parts by hand and thoroughly dry.
Thoroughly clean all parts that will come in
contact with food before using the appliance.
NEVER rinse appliance Grinder Motor
under tap, only use a moist cloth to clean the
Grinder Motor Unit.
7. Reduce risk of unintentional starting.
Make sure the Power Switch is in the
"OFF" position before attaching to the power
source.
8. KEEP FINGERS CLEAR of the
Auger and Cutting Blades AT ALL
TIMES. NEVER REACH INTO THE
GRINDER, doing so may cause serious
injury. ALWAYS USE THE PROVIDED
STOMPER, NEVER FEED FOOD BY
HAND.
SAVE THESE INSTRUCTIONS
9. NEVER use fingers to scrape food away
from the Grinding Plate while the Grinder is in
operation. SEVERE INJURY MAY RESULT.
10. NEVER LEAVE THE GRINDER
UNATTENDED. Be safe, DISCONNECT the
Grinder from power source before leaving the
work area. Close supervision is necessary
when any appliance is used near children. This
appliance is NOT to be used by children.
11. Wait until all moving parts have stopped
before you remove any part of the Grinder, or
before switching the Grinder in reverse.
12. TIE BACK loose hair and clothing, and roll
up long sleeves before operating the Grinder.
REMOVE ties, rings, watches, bracelets, or other
jewelry before operating the Grinder.
13. Be sure the Grinder is on a stable work
surface. Be sure all the Grinder Feet are stable.
14. DO NOT attempt to grind bones or other hard
items.
15. DO NOT run Grinder without meat in the
Head. Severe damage to the Head and Auger
may occur.
16. WEAR EYE PROTECTION. Wear safety
glasses. Everyday eye glasses are not safety
glasses. Safety glasses conform to ANSI Z87.1
requirements. Note: approved safety glasses
have Z87 printed or stamped on them.
17. DO NOT use outdoors.
18. DO NOT use the Grinder while under the
influence of drugs, medications or alcohol.
19. DO NOT let the Power Cord hang over edge
of work surface.
20. DO NOT attempt to operate the Grinder
if the Grinder itself is cold. The Grinder
temperature should be at least 45
beginning.
21. The Gear Housing and the Motor Cover may
become HOT during operation. This is normal.
DO NOT touch these parts during operation or
until they cool after use.
F (7
C) before
o
o
3
Publicité
