Mitsubishi Electric PAC-YT53CRAU Manuel D'installation page 21

8If the set settings need to be changed, repeat steps 4 to 7.
To complete the settings, press the [MODE] and the [
seconds or longer.
Response has been received.
[TEMP.
Indoor unit address setting
■ Checking the indoor unit Function Setting Value
1Perform the Procedure A on the previous page.
2Press the [TEMP.
settings to be checked. (0 to 50)
3Press the [MODE] button, then press the [TEMP.
Function Setting No. to be checked. (000 to 255)
4Press the [ FAN] button to display the current Function Setting Value.
] [TEMP. ]
[MODE]
Function Setting No. setting
Waiting for response
Response has been received.
Setting completed
] and the [TEMP. ] buttons to set the address of the indoor unit whose
– 21 –
FAN] buttons at the same time for two
[MODE]
Function Setting Value setting
[ON/OFF]
No
response
The specified indoor unit does not
exist.
The setting for the specified
Function Setting No. has not been
2 sec.
completed.
[MODE]
+
[FAN]
] and the [TEMP. ] buttons to set the