CLIMAVENETA MHD 30 Mode D'emploi page 34

WIRELESS REMOTE CONTROL
Signal transmitter
A
H
D
E
C
Be sure that there are no obstructions between receiver and
remote controller; Don't drop or throw the remote control;
Don't let any liquid in the remote control and put the remote
control directly under the sunlight or any place where is very
hot.
Indicator symbols
AUTO
COOL
DRY
FAN
HEAT
Low FAN
Middle FAN
High FAN
Clock
Light
Sleep
Temp
Padlock
12
All manuals and user guides at all-guides.com
A. ON/OFF button
Press this button, the unit will be turned on, press it once
more, the unit will be turned off.
When turning on or turning off the unit, the Timer, Sleep
function will be canceled.
B. MODE button
Auto, Cool, Fan, Heat mode can be selected circularly.
Fan mode is default while power on. Under Fan mode,
the temperature will not be changed, it shows 24°C
(75°F). Under Heat mode, the initial value is 28°C (82°F);
Under other modes, the initial value is 25°C (77°F).
B
G
L
M C. SLEEP button
Sleep On and Sleep Off can be selected. After powered
N
on , Sleep Off by default. After the unit is turned off, the
Sleep function is canceled. After Sleep function set up,
F
the signal of Sleep will display. In this mode, the time of
timer can be adjusted. Under Fan and Auto modes, this
I
function is not available.
D. FAN button
Auto, Low, Middle, High speed can be circularly selected.
After powered on, Auto fan speed is default. Under Dehu-
midify mode, Low fan speed only can be set up.
Under the Dry mode, the fan speed isn't adjustable.
E. CLOCK button
Press this button, the clock can be set up, signal
on display. Within 5 seconds, the value can be adjusted
by pressing + or - button, if continuously press this button
for 2 seconds above, in every 0.5 seconds, the value on
ten place of Minute will be increased 1. During blinking,
repress the Clock button, signal
played and it denotes the setting succeeded. After pow-
ered on, 12:00 is defaulted to display and signal
be displayed. If
value is Clock value, otherwise is Timer value.
F. LIGHT button
Press this button to select LIGHT on or off in the display-
er. When the LIGHT on is set, the icon
played and the indicator light
on. When the LIGHT off is set, the icon will be displayed
and the indicator light in the displayer will be off.
G.
For presetting temperature increasing. Press this button,
can set up the temperature, when unit is on. Continuous-
ly press and hold this button for more than 2 seconds, the
corresponding contents will be changed rapidly, until
unpress the button °C (°F) laying all along. In Auto mode,
the temperature can not be set up. Centigrade setting
range: 16-30; Fahrenheit scale setting range 61-86.
AUTO
AUTO
symbol is displayed the current time
in the displayer will be
button
User
blink
will be constantly dis-
will
will be dis-