4
how to operate the appliance
The freezer thermostat automatically regulates the inside temperature of the compartments.
As soon as the appliance is plugged in, the full display lights up and the refrigerator will automatically cool at 4°C.
The appliance now cools continuously until the set temperature has been reached. Do not place anything in the refrigerator until
the set temperature is reached. This usually takes 2 or 3 hours. Then set the thermostat at the desired setting and place food into
the refrigerator.
THERMOSTAT SETTING
To set the thermostat, first you must unlock the control panel.
Press the unlock key
to unlock the control panel. All LEDs will flash 2 seconds to indicate the control
panel is unlocked.
Each time the unlock key
is pressed, the temperature setting changes. The refrigerator can be set at
the following temperatures: 2°C, 4°C, 6°C or 8°C.
After 15 seconds the appliance will cool at the new setting.
The control panel will automatically lock when there is no operation within 30 seconds.
SETTING THE REFRIGERATOR ON STANDBY
To set the refrigerator on standby, press and hold the key
for 10 seconds. After 30 seconds after
releasing the key
the appliance is in standby mode and the entire display is off.
To exit the standby mode, press and hold the key
for 10 seconds.
FREEZER AND REFRIGERATOR THERMOSTAT SETTING
Setting 6-8°C: for short-term storage of food in the freezer compartment, you can set the knob between the minimum and
medium position.
Setting 4°C: for long-term storage of food in the freezer compartment, you can set the knob to the medium position.
Setting 2°C: for freezing fresh food. The appliance will run for colder temperatures. After the food is frozen return the thermostat
to the previous setting.
Attention:
The ambient air temperature, how often the door is opened and the position of the appliance can affect the internal temperature.
These factors must be taken into account when setting the thermostat.
• Never introduce volatile, inflammable or explosive fluids such as alcohol, acetone or petrol because of the risk of explosion.
• A 5 minute delaying function is applied to prevent damage to the compressor of your appliance, when you take the plug out and
then plug it in again to operate it or when an energy breakdown occurs. Your appliance will start to operate normally after 5
minutes.
ACCESSORIES
Ice tray
• Fill the ice tray with water and place it in the freezer compartment.
• After the water has completely turned into ice, you can twist the tray as shown below to get the ice cubes out of the tray.
25
English
•