Fresenius Kabi Exelia Notice D'utilisation page 8

1
2. Slide and lock a plug adaptor
adaptor 4 , making sure that you hear it click into place.
3. Connect the Ethernet cable
4. Connect the other end of the Ethernet cable (RJ45 male plug
the maintenance PC.
5. Plug the mains power adaptor
and into the mains power supply.
WARNING
The wall socket must remain accessible at all times to allow emergency power
supply disconnection.
The module power status LED (
is plugged into the power supply.
The Exelia Maintenance Adaptor power status LED
Maintenance Adaptor is powered and ready for use.
NOTE: The power status LED
is only visible by transparency.
2
3 that is conform to your country into the mains power
3
5
to the Exelia Maintenance Adaptor RJ45 connector
4 into the Exelia Maintenance Adaptor power inlet
4
) lights up green when the Exelia Maintenance Adaptor
9
4
5
6
8
is located inside the Exelia Maintenance Adaptor and
8
7
) to the Ethernet port of
7
9 lights up green if the Exelia
6 .
8