Jenn-Air JMW2427DS Instructions D'installation page 6

2.
Install a foot on the left rear spacer using a
#8-18 x
3 ⁄ " screw.
8
NOTE: Position the foot so the long side of the foot
is facing toward the top of the oven.
A. Spacer
B. Foot
C. #8-18 x
3. In the same manner, install a foot on the right rear of
the oven.
4. Install a front foot on the left front spacer using a
#8-18 x ⁄ " screw.
3
8
NOTE: Position the foot so the long side of the foot
is facing toward the inside of the oven.
A. Front foot
B. #8-18 x
C. Spacer
5. In the same manner, install a front foot on the right
front of the oven.
6
A
B
C
⁄
3 " screw
8
A
B
C
⁄
3 " screw
8
6.
Using 2 or more people, place the oven in its upright position.
7. Go to the "Make Electrical Connection" section in the
Installation Instructions provided with your built-in oven.
Replace Plastic Spacers
1. Remove the screw attaching the plastic spacer (A) to the
right side of the oven.
2. Using the screw removed, install a new plastic spacer (B)
provided with this kit.
A
B
A. Plastic spacer
B. New plastic spacer
3. In the same manner, remove and replace the plastic spacer
on the left side of the oven.
B. New plastic spacer