Jenn-Air JMW2427DS Instructions D'installation page 4

Prepare Built-In Microwave/Oven
Combination
NOTES:
R efer to the following "Installation Instructions" and
■
the "Installation Instructions" section of the Installation
Instructions provided with your built-in microwave/
oven combination.
R efer and adhere to the "Electrical Requirements" section
■
and complete the instructions in the "Make Electrical
Connection" section of the Installation Instructions
provided with your built-in microwave/oven combination.
1. Decide on the final location for the oven. Avoid drilling or
cutting into house wiring during installation.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the oven on cardboard prior to
installation. Do not use the handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
Remember to keep the corner posts and other materials
that may be needed for installation.
4. Remove the hardware package from inside the bag
containing literature.
5.
Move oven and cardboard close to the oven's final location.
Remove Oven Door
IMPORTANT: Use two hands to remove the oven door.
1. Prior to removing the oven door, prepare a surface where
you will place it. This surface should be flat and covered
with a soft blanket, or use the corner posts from your
packaging material.
2.
Open the oven door.
3. Locate the oven door hinge locks in both corners of the
oven door, and rotate the hinge locks toward the oven door
to the unlocked position. If the door hinge lock is not
rotated fully (see illustration B), the door will not remove
properly.
A. Oven door hinge lock in
locked position
4
INSTALLATION INSTRUCTIONS
A
B. Oven door hinge lock in
partially unlocked position
4.
Partially close the door to engage the door latch locks.
The door will stop at this point.
5. Using two hands, grasp the edges of the oven door. Lift and
pull the oven door toward you and remove it. You may need
to gently shift the door from side to side as you pull.
6.
Set the oven door aside on the prepared covered work
surface, with the oven door resting on its handle.
7. To continue with the oven installation, go to the "Positioning
Oven Feet" section.
Replace Oven Door
1.
Using two hands, grasp the side edges of the door at the
midpoint. Face the oven cavity.
2. Locate the slots on each side of the oven cavity for the
door hinge locks.
B
A. Slot in the oven cavity for door hinge lock
A