Jenn-Air JMW2427DS Instructions D'installation page 5

3.
At a 45° angle, align the door hinges with the slots in the
lower front of the oven cavity. Slowly insert the door, making
sure you maintain the 45° angle. You will know the door is
engaged in the slot when you feel a slight drop.
4. Lower the oven door to the fully open position. If the oven
door does not open to a full 90°, repeat steps 1 through 3.
5.
Locate the oven door hinge locks in the corners of the oven
door, and rotate the hinge locks toward the oven cavity to
the locked position.
See Step 3 (illustration A) in the "Remove Oven Door"
section for the proper locked position.
6. Close the oven door.
7. When the hinges are properly installed and the door is
closed, there should be an even gap between the door and
the control panel. If one side of the oven door is lower than
the other, the hinge on that side is not properly installed.
Repeat the steps to remove and replace the oven door. See
"Remove Oven Door" and "Replace Oven Door."
Positioning Oven Feet
The oven feet need to be installed to allow a microwave/oven
combination to be installed in a recommended cutout height of
42 ⁄ " (107.9 cm).
1
2
NOTE: Do not remove the spacers.
1.
Using 2 or more people, place the oven on its back on a
covered surface.
A
A. Spacers
5
5