Kärcher M 80 Mode D'emploi page 8

Operation
Operating elements
A Device with coin slot
B Device with start button
1 Throwing in the coin
2 Indicator lamp
3 Coin return
4 Start button
5 Mat feeder
6 Mat ejector
Cleaning the mat
Device with coin slot:
 Insert a coin in the coin slot.
The device starts.
Device with start button:
 Press the start button.
START
The device starts.
 Turn the side of the mat to be
cleaned downwards.
 Push the mat into the mat feed-
er and hold it.
 Insert, withdraw, and turn the
mat in the device several times
until all points of the mat have
been cleaned.
 Pull the mat out of the device.
Note:
If the mat is released, it will move through
the device and be ejected at the mat ejec-
tor.
Settings
Setting the run time
Note:
The adjustable run time applies to the in-
sertion of one of the following coins:
– 50 Eurocents
– 50 British pence
– 1 Swiss franc
– 1 Polish złoty
– 5 Norwegian Kroner
 Remove the lid (see "Maintenance and
care/Maintenance tasks/Removing the
lid").
8
1 "PRG" button
2 LED 3
3 LED 1
4 "P1" button
5 Control
 Press the "PRG" button and hold it
down until LED 3 illuminates.
The "adjustment" operating mode is ac-
tivated.
Note:
The "adjustment" operating mode will end if
no buttons have been pressed for 10 sec-
onds.
The adjustment begins with a run time of 0
seconds.
Maximum run time is 10 minutes. If this set-
ting is reached, LED 1 will flash quickly.
 Press the "P1" button briefly.
LED 1 flashes quickly and the run time
is increased by 5 seconds.
 Press and hold the "P1" button.
LED 1 flashes slowly and the run time is
increased by 30 seconds.
 Set the desired run time by pressing the
"P1" button repeatedly.
 To confirm the set run time, press the
"PRG" button until LED 3 flashes quick-
ly:
The run time has now been saved.
Shutting down
 Set main switch to "0".
Maintenance and care
DANGER
Risk of injury due to inadvertently starting
up device and also due to electric shock.
 Before starting any maintenance and
care work, turn the main switch off "0"
and ensure that it will not be turned on
accidentally.
Daily
 For device with coin slot: Empty the
coin cassette (see "Maintenance
tasks").
 Empty the dirt receptacle (see "Mainte-
nance tasks").
 Check the general condition of the de-
vice.
 Have damaged parts replaced.
Weekly
 Remove dirt from the mat ejector.
 Clean the device.
Every 500 cycles
 Lubricate the locks with penetrating oil
(Caramba, WD 40).
2
-
EN
Every 8000 cycles
 Replace the brush (see "Maintenance
tasks").
Maintenance Works
Emptying the coin cassette
1 Door
2 Lock
3 Coin cassette
 Open door.
 Remove and empty the coin cassette.
Removing the front cover
1 Lock
2 Cover
 Open locks.
 Remove cover.
Emptying the dirt receptacle
 Remove the front cover (see above).
1 Dirt receptacle
(not included in delivery)
 Remove and empty the dirt receptacle.
 Reinsert the dirt receptacle.
 Install and lock the cover.