Publicité
Les langues disponibles
Les langues disponibles
4) when you have finished, refit the rotor
arms
in
the
remembering to re-align the arrow and
screw into position (fig.4).
5) Both the door lining and the tank lining
are in stainless steel; however, should
spots caused by oxidation occur, this is
probably due to a high level of iron salts
presents in the water.
6) The spots can be removed with a mild
abrasive agent; never use chlorine
based materials, steel wool, etc.
same
position,
115
WHEN CYCLE IS FINISHED.
After every wash it is essential to turn off
water supply and to switch off the machine
by pressing the On/Off button to the off
position.
If the machine is not going to be used for
some time, it is advisable to follow these
rules:
1. do an empty wash with detergent in
order to clean the machine of any
deposits;
2. pull out the electric plug;
3. turn off the water tap;
4. fill the rinse aid container;
5. Ieave the door ajar;
6. keep the inside of the machine clean;
7. If the machine is left in places where the
temperature is below 0°C any water left
inside the pipes may freeze. Wait until
the temperature rises above zero and
then wait for about 24 hours before.
Publicité
