Hoover H-DISH 300 HF 3C7L0W Mode D'emploi page 120

- SETTINGS
The dishwasher is regulated with certain
factory settings.
SETTINGS menu, you can adjust
various parameters to suit your washing
requirements.
The parameters adjusted are:
SOFTENER
To adjust the softener, see the specific
chapter of the manual.
BUZZER
Activates or deactivates the acoustic signal
at the end of the programme.
MEMO FUNCTION
To enable storage of the last used
programme.
ENTERING THE SETTINGS MENU
The dishwasher must ALWAYS be
turned off before
procedure.
Turn on the dishwasher by holding the

"ON/OFF" button for approximately 3
seconds.
Hold the "SETTINGS"

seconds to open the menu. Entering the
settings mode will be indicated by flashes
from several of the indicator lights on the
dashboard.
You can now choose what you want to

set.
BUZZER
Press the "HALF LOAD/TABLETS"

button to activate or deactivate the
acoustic indicator.
- The buzzer will remain active if the
"HALF LOAD/TABLETS"
light switches on and a sound is heard;
However, from the
you start this
button for 5
indicator
- The buzzer will remain inactive if the
"HALF LOAD/TABLETS"
indicator light does not come on and no
sound is heard;
Press the "START/RESET"

save the settings and exit the settings
menu.
MEMO FUNCTION
To enable memorisation
programme used, proceed as follows:
Press the "DELAY START/SETTINGS"

button to activate or deactivate the
MEMO FUNCTION.
- The MEMO FUNCTION will be active if
the "6h" indicator light comes on.
- The MEMO FUNCTION will be inactive if
the "6h" indicator light does not come
on.
Press the "START/RESET"

save the setting and exit the settings
menu.
CHILD LOCK
The dishwasher is equipped with an
electronic child lock. The child lock disables
the controls, thereby preventing unwanted
or accidental changes from being made.
Turn the child lock feature on and off as
follows:
Turn on the dishwasher by holding the

"ON/OFF"
approximately 3 seconds.
Press the "CHILD LOCK"

approximately 5 seconds.
Only the "ON/OFF"

active.
120
option
button to
of the last
button to
button down for
button for
buttons will remain