Hoover H-DISH 300 HF 3C7L0W Mode D'emploi page 123

With cycle not in progress:

The "P5" indicator light will turn on when
the cycle - activated from the app - starts.
With cycle already in progress:

The cycle-in-progress indicator light will
remain on until the cycle is completed.
DISABLING REMOTE CONTROL
To exit remote control mode, press the

"Wi-Fi" button on the dishwasher again.
The "Wi-Fi" indicator light will blink very

slowly.
With cycle not in progress:

It will be possible to manually select a
new cycle.
With cycle in progress:

The cycle-in-progress indicator light will

remain on until the cycle is completed.
The cycle will be completed without being

controlled via the App.
An alternative way to exit remote control
mode.
Press and hold the "START/RESET"

button for 3 seconds.
If there is a cycle in progress, it will be
cancelled and the appliance will exit
REMOTE CONTROL mode.
The "Wi-Fi" indicator light will flash
slowly. It will now be possible to set a
new wash cycle from the control panel.
Press and hold the "ON/OFF" button

for 3 seconds (or power off).
If there is a cycle in progress, it will be
paused and the appliance will exit
REMOTE CONTROL mode.
When switching it on again, the "Wi-Fi"
indicator light will flash slowly and any
cycle in progress will continue from the
point of interruption.
If the appliance is switched off and
then on again - either via the ON/OFF
button or as a result of a power failure
-when REMOTE CONTROL is enabled
and a wash cycle is in progress, the
cycle will continue from the point of
interruption.
In this case, "REMOTE CONTROL"
will be disabled.
Opening the
CONTROL will be disabled. To resume
control from the App, close the door.
Wi-Fi connection indicator light
This indicator light indicates the connection
status:
- ON: remote control enabled.
- FLASHING VERY
control disabled.
- FLASHING SLOWLY: reset from the
Wi-Fi network (during App pairing).
- FLASHING RAPIDLY:
appliance paired with the app but no Wi-Fi
connection. Check the correct operation of
the router or the updated home Wi-Fi
credentials (Network
password). In this case, update the app
settings, following the instructions on your
smartphone.
123
door, any REMOTE
SLOWLY: remote
name and/or