Qilive Q.6598 Manuel D'utilisation page 29

9. TROUBLESHOOTING
9.1. ERROR CODES
If there is a malfunction, the dishwasher displays an error code.
Codes Meaning
E1 Longer inlet time.
Not reaching required
E3
temperature.
E4 Overflow.
Failure of orientation of
E8
the distributary valve.
Warning:
■ If an overflow occurs, turn off the main water supply before calling for service.
■ If there is water in the base pan because of an overflow or a small leak, remove
the water before restarting the dishwasher.
9.2. BEFORE CALLING FOR SERVICE
Problem Possible Causes
Fuse blown or the
circuit breaker is
tripped
Power supply is not
Dishwasher
turned on.
doesn't
start.
Water pressure is
low.
The dishwasher
door is not closed
properly.
Twisted or trapped
drain hose.
Water not
pumped
Filter clogged.
from
dishwasher.
Kitchen sink clogged.
Possible Causes
Faucets not open, water intake is restricted,
or water pressure is too low.
Malfunction of the heating element.
Some element of the dishwasher leaks.
Open circuit or a break in the distributary
valve.
What to Do
Replace the fuse or reset the circuit
breaker. Remove any appliances sharing
the circuit with the dishwasher.
Make sure the dishwasher is turned on and
the door is closed securely. Make sure the
power cord is plugged into the wall socket.
Check that the water supply is connected
properly and the water is turned on.
Make sure to close the door properly and
latch it.
Check the drain hose.
Check the coarse filter.
Check the kitchen sink to make sure it is
draining well. You may need a plumber.
29
EN