Télécharger Imprimer la page

Qilive Q.6598 Manuel D'utilisation page 17

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
4. BEFORE FIRST USE
1.
Unpack all parts.
2.
Check for completeness and shipping damage immediately after unpacking. If
your shipment is damaged or incomplete, please contact our customer service.
5. INSTALLATION
Warning! Electrical Shock Hazard. Disconnect the electrical power before installing the
dishwasher. Failure to do so could result in death or electrical shock.
Attention! The installation of the pipes and electrical equipment should be done by
professionals.
5.1. POWER CONNECTION
Warning! For personal safety, do not use an extension cord or an adapter plug with
this appliance.
Warning! For personal safety, do not, under any circumstance, cut or remove the
earthing connection from the power cord.
Electrical Requirements
Examine the rating label to ensure you know the rating voltage and connect the
dishwasher to the appropriate power supply. Use the required fuse 10A/13A/16A, time
delay fuse, or circuit breaker recommended and provide a separate circuit serving only
this appliance.
Electrical Connection
Ensure the voltage and frequency of the power source corresponds to those on the
rating plate. Only insert the plug into an electrical socket which is earthed properly. If
the electrical socket to which the appliance must be connected is not appropriate for
the plug, replace the socket, rather than using adapters or similar devices as they could
cause overheating and burns.
Caution! Ensure that the proper earthing exists before use.
5.2. WATER SUPPLY AND DRAIN
Cold Water Connection
Connect the cold-water supply hose to a threaded 3/4" connector and make sure it is
securely fastened and is tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the
water run first, to ensure the water is clear. This precaution is necessary to avoid the
risk of the water inlet becoming blocked and damaging the appliance.
About the Safety Supply Hose
The safety supply hose consists of double walls. The hose's system guarantees its
intervention by blocking the flow of water in the case of the supply hose breaking and
when the air space between the supply hose and the outer corrugated hose is filled
with water. See
Figure
Warning! A hose that attaches to a sink spray can burst if it is installed on the same
water line as the dishwasher. If your sink has a sink spray, it is recommended that the
hose be disconnected and the hole plugged.
C.
17
EN

Publicité

loading