Publicité
Les langues disponibles
Les langues disponibles
mm
Type
Type
Instructions for assembly
Clips
•
Drive the clips into the worktop
cut-out at the intervals indicated.
•
It is not necessary to adjust the
height due to the horizontal stop.
•
The horizontal drive of the clips
must be fl ush with the worktop
(avoid the risk of fractures).
•
Position the hob according to the
illustration on the left side (a),
align it (b) and insert the clips (c).
•
Screws may be used to fasten
the clips.
Important:
There is a risk of breakage if the
hob is canted or subjected to stress
during installation!
Minimum distance to adjacent
walls
Cut-out dimension
Outer dimensions of the hob
Cable routing in rear wall
Installation height
Bracket
•
Insert the hob and align it.
•
From the bottom, insert the
brackets with screws in the
holes provided for fastening the
brackets, align the brackets and
screw them tight.
•
Tighten the screws with a hand
screw driver only; do not use a
battery-operated screw driver.
•
In the case of thin worktops
make sure that the brackets are
correctly positioned.
Important:
There is a risk of breakage if the
hob is canted or subjected to stress
during installation!
GB
39
Publicité
