Braun 5769 Mode D'emploi page 10

• If you regularly clean the shaver under water, then once a week apply a drop of light
machine oil on top of the Foil & Cutter cassette.
The shaver should be cleaned after each foam usage.
Cleaning with a brush
• Switch off the shaver. Remove the Foil & Cutter cassette (1) and tap it out on a flat
surface. Using the brush, clean the inner area of the pivoting head. Do not clean the
cassette with the brush as this may damage it!
Battery removal
This appliance contains a rechargeable battery. Before disposing of the appliance,
disassemble the housing as shown, remove the rechargeable battery and recycle or
dispose of properly, according to local guidelines.
Caution: Disassembling the appliance will destroy it and invalidate the warranty.
Clean&Charge Station (C&C)
The Clean&Charge Station has been developed for cleaning, charging, lubricating,
drying and storing your Braun shaver.
Important
Only use the special electric cord set supplied with the shaver as power supply.
To prevent the cleaning fluid from leaking, ensure that the Clean&Charge Station is
placed on a flat surface. When a cleaning cartridge is installed, do not tip, move
suddenly or transport the station in any way as cleaning fluid might spill out of the
cartridge.
10
1
1
Li-Ion
(not with all models)
2