Publicité
Les langues disponibles
Les langues disponibles
The Digital Control Board system is an intricate and valuable piece of technology. For protection from power surges and electrical
shorts, consult the wire diagram below to ensure your power source is sufficient for the operation of the unit.
PB – ELECTRIC REQUIREMENTS
110-120 V, 60 Hz, 250 W, 3-PRONG GROUNDED PLUG
NOTE: Electrical components, passed by product safety testing and certification services, comply
with a testing tolerance of ± 5-10 percent.
FUEL INPUT
RATING:
1.12 KG/H
(2.48 LB/H)
GROUNDED
POWER CORD
IGNITOR ASSEMBLY /
HD CARTRIDGE HEATER
120 V, 200 W
INDEX
K : BLACK
W : WHITE
R : RED
Y : YELLOW
P : PURPLE
O : ORANGE
G : GREEN
ELECTRICAL WIRE DIAGRAM
1. Locate and remove
the four screws of
access panel on the
side of hopper.
GROUND
W
P
R
AUGER MOTOR
& FEED SYSTEM
120 V, 60 Hz,
2 RPM MOTOR
2. Release bottom hopper
panel down and slide
back to unseat from tabs.
CONTROL BOARD
K
W
R
W
K
R
GRILL PROBE
Y
Y
DRAFT FAN
120 V, 60 Hz,
1 PHASE
21
Publicité
