Garland HUNTER 1269 SML Manuel D'instructions page 41

6.2.2. ASSEMBLING THE DRAW BAR AND SWITCH
Insert the metal
tip of the upper
wire through
the hole in the
switch bar
Then insert the
bar through
the two holes,
making a
slight pressure
inwards.
Insert the metal tip of the
lower cable through the hole
in the drawbar.
Then insert the bar through the two holes, making a
slight pressure inwards.
6.2.3. MOUNTING THE BAG
Place the bag with the clips around the bar as shown
in the figure.
1
Then lift the rear outlet cover and engage the chassis
protrusions of the bag (1) into the recess of the
handlebar coupling
41/144
English
1