Onkyo CR-255 Manuel D'instructions page 17

Playing CDs
This section describes the procedure for using the
remote controller, unless otherwise specified.
Playing CDs
1 Press the CD receiver's [0] button to open
the disc tray.
Tip:
• Pressing the [0] button while the CD receiver is on
Standby will turn on the CD receiver and open the disc
tray.
2 Place CD on the tray with the label-side
facing up.
Place 8 cm CDs in the center of the tray.
3 To start playback, press the CD receiver's
[1/3] button.
Alternatively, press the remote controller's [1/
3] button.
The disc tray closes and playback starts.
Then the "1" indicator appears.
To stop playback:
Press the [2] button.
To pause playback:
Press the [1/3] button. The Pause "3" indicator
appears. To resume playback, press the [1/3] button
again.
To Fast-Forward or Fast-Reverse:
During playback, press and hold the Fast Forward [4]
button to fast forward, or the Fast Reverse [5] button
to fast reverse.
To remove the CD:
Press the CD receiver's [0] button to open the disc tray.
■ Information Displayed When Playback is
Stopped:
• Audio CD
CD „ „ „ „ 1 9„ † „ „ 6 7„ ‡ 2 9
Total number of tracks
"DISC TOTAL" lights up
Total playing time
Selecting Tracks
To return to the beginning of the track currently playing,
press the Previous [7] button.
Press the Previous [7] button repeatedly to select
earlier tracks.
Press the Next [6] button repeatedly to select
subsequent tracks.
Displaying CD Information
During playback or while playback is paused, press the
[DISPLAY] button repeatedly to display the following
CD information.
• Elapsed time
• "REMAIN"
Lights up while the remaining track time is being
displayed.
• "TOTAL REMAIN"
Lights up while the remaining disc time is being
displayed.
• Type of CD
17
En-