Onkyo CR-255 Manuel D'instructions page 15

Connecting the Antennas
■ Using a TV/FM Antenna Splitter
It's best not to use the same antenna for both FM and TV
reception, as this can cause interference problems.
If circumstances demand it, use a TV/FM antenna
splitter, as shown.
Connecting Other Components
Analog audio
cable (RCA)
About Connections
• Before making any connections, read the manuals
supplied with your other components.
• Don't connect the power cord until you've completed
and double-checked all connections.
Push plugs in all the way to make
good connections (loose connections
can cause noise or malfunctions).
Note:
• Do not put anything on top of the CD receiver, as it
may interfere with proper ventilation.
Connecting an Audio Playback
Device
Using a suitable cable, connect the CD receiver's LINE
IN jacks to the OUTPUT (PLAY) jacks of your cassette
tape deck, TV, or other audio playback device.
—Continued
CD receiver
e.g., cassette tape deck
Connect the CD receiver's power cord to a suitable wall
outlet.
Note:
• Do not use any cord other than the included power
Right!
• Do not connect the included power cord to any other
• Do not unplug the power cord from the AC INLET
Wrong!
• Before connecting the power cord, connect all of your
• Turning on the CD receiver may cause a momentary
• Plug the power cord into an AC outlet that is easily
TV/FM antenna
To CD receiver
(Connector type varies from
country to country.)
Connecting the Power Cord
cord.
device. Doing so may cause malfunctions or
accidents.
while the other end of the cord is still connected to an
AC outlet. You may receive an electric shock if you
accidentally touch the internal terminals of the power
cord.
speakers and AV components.
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the receiver into a different branch circuit.
accessible so that you can quickly unplug it if
necessary.
splitter
To TV (or VCR)
To wall outlet
En-
15