Teka HGE-824 Guide D'utilisation page 91

• Also ensure that the regulation is enough to
keep the thermocouple hot.
• Turn off the burner and then, after cooling,
replace the floor plate and accessories.
Caution:
To regulate the minimum level when changing
from liquid gas to methane gas you only need
to loosen the bypass screw.
To operate with gas G30/G31 (LPG), the
bypass regulating screw must be completely
tightened.
Once these steps (replacing the injectors,
regulating air flow and minimum levels) have
been completed, turn off the oven and replace
the identification plate with the new one
(specifying the gas used).
If there is a problem with the thermostat,
contact Technical Service.
31