Teka HGE-824 Guide D'utilisation page 87

6 Once they are clean, replace the glass
panels in the same order so that you can
read the printed TERMOGLASS labels on
them.
7 Re-attach the seal over the door, assuring
that the side tabs fit in Point 1.
Changing the oven light bulb
Caution:
Make sure the oven has been disconnected
from the mains before changing the bulb.
For your oven model, follow these instructions:
• Release the bulb-holder glass cover with a
tool. Fig. 9
• Change the bulb.
The replacement
temperatures up to 300 ºC. You can order one
from the Technical Assistance Service.
• Reassemble the glass cover and ensure that
everything fits in the correct position.
Fig. 10
bulb must withstand
Technical Specifications
This appliance must
permanently ventilated premises according to
the regulations applicable in your country.
If the appliance does not work, inform Technical
Service of the kind of problem you are
experiencing and give the:
1 Serial Number (S-No)
2 Model of Appliance (Mod.)
You will find this information engraved on the
identification plate. This plate is located on the
side of the oven and can be seen when
opening the door.
Any kind of maintenance must be carried out
by skilled or authorised personnel, with the
appliance disconnected and the gas supply
cut off.
be installed in
27