Teka HGE-824 Guide D'utilisation page 88

Installation
It is important that all operations relating to the
installation, regulation and maintenance of the
appliance are carried out by skilled and
competent personnel in accordance with the
rules and regulations in force.
The manufacturer will not accept liability for
possible damage caused if you install the oven
yourself.
Premises where it is installed
• This appliance must not be connected to a
combustion products evacuation device.
• The appliance must be installed and only used
in premises that are permanently ventilated
according to rules and regulations in force.
• The natural air current must reach directly
through permanent openings in the exterior
walls of the premises, or through individual
or branch ventilation ducts. Fig. 11
• The ventilation openings must incorporate a
useful section of at least 100 cm
not be accidentally obstructed (protection
with metal grilles or wire mesh).
• The premises must have a smoke evacuation
system in the form of an extractor hood or an
electric fan that operates when the appliance
is switched on. Fig. 11
Installation in the unit
• It is important that all operations relating to
the installation of the appliance are carried
out by skilled and qualified personnel.
• The appliance may be fitted under a worktop
or into a wall unit. In both cases, the
dimensions specified in figure 12 must be
adhered to.
• The unit where the appliance is to be fitted
must be suitably secured.
28
• To unpack the oven, pull on the tab located
at the bottom of the box and hold it by the
sides, never by the oven door handle.
• The installation of the oven in the unit must
be carried out in accordance with the
following instructions (Fig. 12):
1 Remove the frame covers by loosening
screws A.
2 Connect the oven to the mains power and
gas supply, then insert it into the unit.
3 Secure the oven to the unit with 2 wood
screws B (supplied).
4 Attach the frame covers.
• Do not use the door as a lever when
installing the oven.
• Do not apply pressure to the oven door when
it is open.
Caution:
The adhesive used in the plastic lining of the
kitchen units must be able to withstand
temperatures higher than 90 ºC.
2
and must
• The device must be connected to the mains
gas supply or to the gas cylinder according to
the rules and regulations in force after
ensuring that it has been regulated for the
type of gas available.
• The appliance is ready to operate with the
gas specified on the calibration label located
on the bottom of the oven frame.
• If the type of gas available does not
correspond to that of the appliance, the
corresponding injectors (supplied) must be
changed. A new calibration label (supplied)
must be placed and the old one removed.
• The
specifications outlined in the section
"Adaptation to different types of gas" to
comply with these conditions.
Gas Connection
skilled fitter must follow the