Publicité
Les langues disponibles
Les langues disponibles
English
APPLICATIONS
Wood and aluminum sash.
PREPARATION BEFORE OPERATION
Make the following preparations before operating the power tool:
1.
Remove all packing materials attached or connected to the tool before attempting to operate
it.
2.
Installation
11/32" (9 mm)
4 holes
10-23/64"
(263 mm)
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8 mm) diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 1-9/16" (40 mm) plus the thickness of the work bench.
For example, use 2-9/16" (65 mm) or larger bolts for a 1" (25 mm) thick work bench.
The support rod ass'y attached to the rear of the base helps stabilize the power tool.
Support
5 mm screw
rod ass'y
Hole
Fig. 5
12
11-39/64"
(295 mm)
Fig. 4
Installing the support rod ass'y
Insert one support rod ass'y into the hole located at the
rear of the base and push it in as far as it will go.
Thread the 5 mm screw into the hole next to the
mounting hold.
Firmly tighten the 5 mm screw with a screwdriver.
Repeat the above steps for installing the other support
rod ass'y.
Base
5/16" (8mm) bolt
Work bench
5/16" (8 mm) nut
Publicité
