Makita AN611 Manuel D'instruction page 6

1. To drive a nail, you may place the contact element
against the workpiece and pull the trigger, or
2. Pull the trigger first and then place the contact ele-
ment against the workpiece.
• No. 1 method is for intermittent nailing, when you
wish to drive a nail carefully and very accurately.
No. 2 method is for continuous nailing.
CAUTION:
• However when the tool is set to the "Intermittent
Nailing" mode, WITH THE TRIGGER HELD IN A
HALF-PULLED POSITION, an unexpected nailing
could occur, if contact element is allowed to re-con-
tact against the workpiece or the other surface
under the influence of recoil.
In order to avoid this unexpected nailing, perform as
follows;
A. Do not place the contact element against the work-
piece with excessive force.
B. Pull the trigger fully and hold it on for 1-2 seconds after
nailing.
• For No. 1 method, set the change lever to the "Inter-
mittent Nailing" position.
For No. 2 method, set the change lever to the "Con-
tinuous Nailing" position.
After using the change lever to change the nailing
method, always make sure that the change lever is
properly set to the position for the desired nailing
method.
005245
005246
1
2
CAUTION:
• Operating the tool without nails shortens the life of
the tool and should be avoided.
Air exhaust
Air exhaust direction can be changed easily by rotating
the exhaust cover. Change it when necessary.
Jammed nailer
CAUTION:
• Always lock the trigger, disconnect the hose and
remove the nails from the magazine before clean-
ing a jam.
When the nailer becomes jammed, do as follows:
Open the door and magazine cap and remove the nail
coil. Insert a small rod or the like into the ejection port
and tap it with a hammer to drive out the nail jamming
from the ejection port. Reset the nail coil and close the
magazine cap and door.
6
005247
1. Intermittent nail-
ing
2. Continuous nail-
ing
3
3. Change lever
4. Trigger lock
4
005613
1. Exhaust cover
1
005614
1. Small rod
1
2. Ejection port
2