Zanussi ZQS 6140 Mode D'emploi page 47

Building in the appliance under a worktop
Grid preparation
Left door opening:
Remove the left side (A) of the grid cutting it from the
rear (see figure).
A
DO002/2
Right door opening:
Remove the right side (B) of the grid cutting it from
the rear (see figure).
To position the grid on the appliance proceed as
follows:
Apply the grid to the base of the appliance by
pushing on to the clasps (a) until they click.
a
DO001
Building-in
Dimensions of the recess
DO013
The dimensions of the recessed installation area
must correspond with those indicated in the figure.
B
a
1xB
1xA
1
1. Installation kit
2. Two cabinet securing brackets (D) are supplied
with the installation pack. They need to be
assembled onto the cabinet prior to cabinet being
pushed into the Kitchen aperture.
Left hand
bracket
2
- To fit these brackets remove the two screws at the
top left and right hand front corners of the cabinet.
- Position the two brackets as shown in the figure
and replace the two securing screws.
2xC
1xK
18xI
Right hand
bracket
47