Publicité
Les langues disponibles
Les langues disponibles
3. MOUNTING THE LEGS TO MAIN BARREL
Parts Required:
1
x
Support Leg /Back (#30)
1
x
Support Leg /Front (#31)
Support Leg for Caster /Back (#29)
1
x
Support Leg for Caster /Front (#28)
1
x
12 x
Screw (#A)
12 x
Locking Washer (#C)
12 x
Washer (#B)
Installation:
•
Mount one support leg to the floor end of the main barrel using three screws,
locking washers, and washers, through the three pre-drilled holes. Install
screws from the inside of the main barrel. Repeat installation for second
support leg.
•
Mount one support leg for caster to the hopper end of the main barrel using
three screws, locking washers, and washers, through the three pre-drilled
holes. Install screws from the inside of the main barrel. Repeat installation
for second support leg for caster.
NOTE: Fasten screws of the support legs only half-way to allow easier
installation of bottom shelf in next step.
4. INSTALLING THE BOTTOM SHELF
Parts Required:
Cart Bottom Shelf (#27)
1
x
Screw (#A)
4
x
4
x
Locking Washer (#C)
4
x
Washer (#B)
Installation:
•
Attach the cart bottom shelf using a washer, locking washer, and screw on
each of the support legs by hand, but fasten only half-way.
NOTE: The side of the bottom shelf with two holes should be assembled
on the gas side.
5. SECURING CART FRONT/BACK PANEL
Parts Required:
2
x
Cart Front / Back Panel (#17)
Screw (#A)
12 x
Locking Washer (#C)
12 x
Washer (#B)
12 x
Installation:
•
Secure cart front/back panel to each leg using two washer, locking washer,
and screw on each of the two support legs.
•
Secure cart front/back panel to barrel using two washer, locking washer,
and screw on each of the two support legs. Repeat installation for the
other cart front/back panel.
NOTE: Once all screws are installed, then tighten securely into the legs.
3
29
28
30
31
4
27
B
C
A
5
17
A C B
9
Publicité
