Inventum HN297V Mode D'emploi page 18

2
appliance description
1. Control
2. Illuminated display
3. Button for adjusting the body area temperature
4. Button for setting the automatic switch-off time
5. Button for adjusting the foot area temperature
6. ON/OFF switch
7. Button for displaying the kWh
8. Plug-in coupling
9. Supply plug
3
intended use
CAUTION
This electric underblanket is designed for warming beds, only.
4
operation
4.1 Safety
CAUTION
• This heated underblanket is equipped with the INVENTUM SAFETY SYSTEM (ISS). This sensor technology prevents the
entire surface of the heated underblanket from overheating by automatically switching off the heated underblanket in the
event of a fault. If the safety system has switched off the heated underblanket, the temperature setting is not illuminated
any more even when the heated underblanket is switched on.
• Please note that the heated underblanket is not operable any more due to safety reasons in this case and has to be sent to
the service address indicated.
• Do not connect the defective heated underblanket with another control of the same type. This would trigger a permanent
switch off via the control's safety system.
4.2 Initial use
• Spread out the heated underblanket flat onto your mattress starting at
the foot end. The electric blanket can be used on both sides.
• To operate the heated underblanket connect the Control to the heated
underblanket by plugging in the connector.
• Then plug in the supply plug into the mains outlet.
• Then put on your bedsheet in the usual manner so that the heated
underblanket is between your mattress and the bedsheet.
CAUTION
Make sure that the underblanket is spread out entirely flat and that it will not rumple up or crease when in use. Check its
position when making the bed.
18
• English
1
2
5
3
6
4
8
7
9