Russell Hobbs RHCK04 Manuel D'instructions page 6


Position the power base on a dry flat surface away from any potential heat
source.

Unwind the length of the mains cable required to reach the mains socket.

Ensure the mains cable does not hang over the work surface edge.
FILLING THE KETTLE

Remove the kettle from the power base.

Open the lid.

Fill the kettle between the MIN and MAX markings on the water level indicator
with cold water.

Close the lid and place the kettle back on the power base. Make sure the lid is
securely closed before boiling.

Always remove the kettle from the power base before filling. Do not fill the kettle
above the MAX mark or below the MIN mark on the water gauge.
SWITCHING ON

Position the kettle on the power base.

Plug the kettle into a mains supply socket.

To start boiling the kettle, press the on/off switch.

The power indicator light will illuminate and the kettle will start to boil.

Never open the lid or touch the stainless steel surface during boiling.

Do not operate this kettle without the filter fitted.
Please beware of escaping steam from the lid of the kettle when in use.
SWITCHING OFF

When the water has boiled, the kettle will switch off automatically. You can stop
the boiling process at any time by lifting the on/off switch to the "0" (off) position
or lifting the kettle off the base.
BOIL-DRY PROTECTION

Should you accidentally switch on an empty kettle - the boil-dry protection will
automatically switch off the power. If this occurs, allow the kettle to cool down
before filling with cold water.
6