Replacing Carbon Brushes; Lubrication - Makita BJS130 Manuel D'instruction

CAUTION:
Edges and chips of the workpiece are sharp. Wear
•
gloves. Otherwise it can cause injury.
Secure the workpiece firmly. Move the tool forward
keeping the side blades flush with the workpiece
surface.
Adjusting shear blade
1
2
3
5
4
009019
Adjust the side blade L so that the curl of waste material
does not contact the cutting head or the workpiece. Use
the hex wrench to loosen the three screws which hold
the cutting head. Move the side blade L back and forth to
adjust it. Then tighten the three screws with the hex
wrench.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.

Lubrication

1
2
3
5
4
009022
Before operation, lubricate the contact point of the
center blade and the side blades R/L. And, also lubricate
the point of the center blade near the cutting head. To
keep good cutting performance, use lubricant from time
to time during operation.
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Sleeve
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Lubricate
7

Replacing carbon brushes

1
006258
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
First remove the holder by unscrewing the hex socket
head bolt.
2
009048
Then loosen the hex socket head bolt that fastens the
barrel and turn the barrel counterclockwise.
1
2
009049
Use a screwdriver to remove two screws then remove
the front cover.
009023
1. Limit mark
1. Holder
1 2. Hex socket head
bolt
1. Barrel
2. Hex socket head
bolt
1. Front cover
2. Screws
1
2