Replacing Carbon Brushes; Optional Accessories - Makita XSC01 Manuel D'instruction

MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Clean out the upper and lower guards to ensure
•
there is no accumulated sawdust which may
impede the operation of the lower guarding
system. A dirty guarding system may limit the
proper operation which could result in serious
personal injury. The most effective way to
accomplish this cleaning is with compressed air. If
the dust is being blown out of the guards be
sure the proper eye and breathing protection is
used.
Never use gasoline, benzine, thinner, alcohol or the like.
•
Discoloration, deformation or cracks may result.
Inspecting blade
Check the blade carefully for cracks or damage
•
before and after each use. Replace a cracked or
damaged blade immediately.
Continuing to use a dull blade may cause a dangerous
•
kickback and/or motor overload. Replace with a new
blade as soon as it no longer cuts effectively.
Blades for metal cutter cannot be re-sharpened.
•

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
007533
1. Limit mark
1
1. Brush holder
1
cap
2. Screwdriver
2
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
After replacing brushes, insert the battery cartridge into
the tool and break in brushes by running tool with no
load for about 1 minute. Then check the tool while
running and electric brake operation when releasing the
switch trigger. If electric brake is not working well, ask
your local Makita service center for repair.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Carbide-tipped blades
•
Rip fence (Guide rule)
•
Thumb screw M5 x 20
•
Compression spring 6
•
Hex wrench 5
•
Safety goggle
•
Makita genuine battery and charger
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
9
or attachments
Only use accessory or
are