Whirlpool W55ZM 112 W 2 N Mode D'emploi page 55

installation operation - risk of
electrical shock.
During installation, make sure the
appliance does not damage the
power cable - risk of re or electrical
shock. Only activate the appliance
when the installation has been
completed.
Be careful not to damage the
oors (e.g. parquet) when moving
the appliance. Install the appliance
on a oor or support strong
enough to take its weight and in a
place suitable for its size and use.
Make sure the appliance is not near
a heat source and that the four feet
are stable and resting on the oor,
adjusting them as required, and
check that the appliance is perfectly
level using a spirit level. Wait at
least two hours before switching
the appliance on, to ensure that
the refrigerant circuit is fully
e cient.
To guarantee
ventilation, leave a space on both
sides and above the appliance. The
distance between the rear of the
appliance and the wall behind the
appliance should be 50 mm, to
avoid access to hot surfaces. A
reduction of this space will increase
the Energy consumption
product.
WARNING: When positioning
the appliance, ensure the supply
cord is not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning or
xing of the appliance must be
done in accordance with the
manufacturer instructions.
It's forbidden to place the freezer
in such way that the metal hose of
gas stove, metal gas or water pipes,
or electrical wires are in contact
with
(condenser coil).
ELECTRICAL WARNINGS
It must be possible to disconnect
the appliance from the power
supply by unplugging it if plug is
accessible, or by a multi-pole
switch installed upstream of the
socket in accordance with the
wiring rules and the appliance
must be earthed in conformity
with national electrical safety
standards.
Do not use extension leads,
multiple sockets or adapters. The
electrical components must not be
accessible to the user after
installation. Do not use the
appliance when you are wet or
adequate barefoot.
Do not operate this appliance if it
has a damaged power cable or
plug, if it is not working properly, or
if it has been damaged or dropped.
If the supply cord is damaged, it
must be replaced with an identical
one by the manufacturer, its service
of
agent or similarly quali ed persons
in order to avoid a hazard - risk of
electrical shock.
WARNING:
multiple portable socket-outlets or
portable power supplies at the rear
of the appliance.
EN - 55
the freezer back
Do not
wall
locate