Publicité
Les langues disponibles
Les langues disponibles
Rangetop
may discolor or chip without cookware to absorb the heat.
Lighting a Surface Burner
WARNING
Burners should be operated only
clothing ignition. Never let flames extend beyond the
in serious injury.
the appropriate burner control knob counterclockwise
to the HI position. Sparking will continue as long as
the knob remains pressed. Once burner is lit, continue
Selecting a Flame Size
Watch the flame, not the knob, as you adjust heat. When
rapid heating is desired, the flame size should match the
size of the cookware you are using. Flames larger than
the bottom of the cookware will not heat faster and may
be hazardous.
If a cooktop burner fails to ignite, you may light the
burner manually by following the instructions below:
counterclockwise to the HI position.
turn it to the HI position.
If the Flame Goes Out
Immediately turn the control knob to OFF position. Wait
at least 5 minutes and light the burner again.
49-2001565 Rev. 0
pressing knob for at least
5 seconds until the flame
sensor is heated. Release
the knob and confirm the
burner remains lit. If the
burner remains lit, rotate
the knob to adjust the
flame. If the burner does
not remain lit, refer to the
Troubleshooting Tips section.
These flames are too large for the pot
While continuing
to press the knob,
immediately
strike and place
a burning long
wooden match or
a gas lighter near
the burner to light.
Once burner is lit,
continue pressing
knob for at least 5
seconds until the
flame sensor is heated. Release the knob and confirm
the burner remains lit. If the burner remains lit, rotate the
knob to adjust the flame. If the burner does not remain
lit, refer to the Troubleshooting Tips section.
Turning Off the Rangetop
To turn the rangetop burners off, rotate the control knobs
objects on the grates until the rangetop has cooled.
turn it to the HI position.
Publicité
