Brandt BPI184HUB Manuel D'instruction page 38

SPECIAL MESSAGES, INCIDENTS SPECIAL MESSAGES, INCIDENTS
DURING INITIAL USE:
- An indicator light appears. This is normal. It
will go away after 30 seconds.
- Your installation blows a fuse or one
side only of the hob works. The electrical
connection of your hob is incorrect. Check its
compliance.
- The hob smells the first few times it is used
for cooking. The appliance is new. Heat up each
ring for half an hour with a saucepan full of water.
6.2
WHEN POWERING ON:
The hob does not work and the indicator
lights on the control panel are not on.
The appliance is not receiving electricity. The
electrical supply is defective or the connection
is incorrect. Inspect the electrical circuit breaker
and fuses.
- The hob does not work and another
message is displayed. The electronic board
is functioning poorly. Call the After-Sales Service
Department.
- The hob does not work, the symbol
displayed. Unlock the child safety device.
- Error code F9: voltage less than 170 V
- Error code F0: voltage less than 5°C
6.3
DURING USE:
- The hob has stopped working. The symbol
is displayed and there is a sound
signal.
There was an overflow or an object is in contact
with the control panel. Clean or remove the
object, then begin cooking again.
- Code F7 is displayed.
The electronic circuits have overheated. Check
the hob's ventilation.
- During operation of a heating zone, the
keypad display continues to flash.
The cookware used is not compatible with
induction or its size is not suitable for the
burner.
- The cookware makes noise and your hob
clicks during cooking (see chapter on Safety
precautions and recommendations 4.5).
This is normal with some types of cookware. This
is caused by the transfer of energy from the hob
18
to the cookware.
- The fan continues to function after your hob
is turned off.
This is normal. It cools the electronic parts.
- In the event of persistent malfunction.
Switch off your hob for 1 minute. If the problem
persists, contact the after-sales service.
is
EN