Eurocave Inoa 25 Mode D'emploi page 21

If you wish to reprogramme the remote control for an internal sensor, disconnect the wired sensor and reprogramme the remote control in internal mode
(IN) by repeating the first two steps described in the paragraph above (see 5-III-b p.11):
The 2nd screen displays
Then repeat the same steps, as indicated in the above paragraph (see 5-III-b)
c - Fitting
- Fit the remote control and sensor using the screws and pegs supplied.
- Place the sensor inside the cellar.
- Place the sensor as close as possible to the bottles
N.B.: the sensor has a range of 3 metres.
V. Setting the temperature
The setting can be adjusted between 9 and 15 C. Beyond this range, the
WARNING : to operate correctly, your conditioner must be in a location where the ambient temperature
is between -5 C is 35 C.
When making significant modifications to temperature settings, it can take several hours for the temperature in your cellar to stabilise and for the conditioner to display
the desired temperature.
VI. Silent function
Your EuroCave conditioner is fitted with a silent function which allows the sound level to be reduced when you enter the cellar.
When the conditioner is on:
- Press and hold down the key for 3 seconds.
display then appears. Next the current temperature is displayed.
The
You will be able to see this function via the
The compressor then remains in operation and the fans change to slow speed for 15 minutes.
After this, the conditioner returns to the default operating speed.
11
GB
7/ COMMISSIONING YOUR CONDITIONER
indicating OUT (OUT= external installation). Press the
pictogram which flashes for 15 minutes.
key to change to IN internal mode. Press
Setting the temperature of your conditioner is carried out
entirely from the remote control which has the following
layout:
- Temperature display: displays the actual temperature inside your
cellar.
- Setting keys: allow you to select the desired temperature inside
the cellar.
To adjust the temperature:
- Press then immediately release the
The setting then appears (the temperature flashes).
- When the temperature flashes, you have 7 seconds to change
the setting by pressing the
automatically returns to the previous setting.
The recommended setting range for maturing wine: 10 to 14 C.
- Press the
returns to the new setting.
keys do not work.
and
to confirm.
key.
keys, otherwise the display
or
key to confirm the new setting, the display then